Showermate eco water boosting shower pumps are the ideal solution to boosting the hot and cold water supply to a single shower, bath, shower mixer or mixer tap, providing an invigorating showering experience.
Designed for domestic use only, Showermate eco pumps will function under positive head conditions and are suitable for installation into open vented hot and cold water systems.
Standard pumps require a flow of just 0.8 l/min through the outlet to start.
- Boost hot and cold water supplies equally
- Single function shower
- Bath/basin mixer tap
General Product code 46500 Guarantee 3 years WRAS approval 1003059 Features Pump type Peripheral Mechanical Seal EPDM / PTFE / Al. Oxide Anti vibration feet Flexible hoses 4 Dry run protection Materials Pump body Plastic Impeller Plastic Performance Maximum head (closed valve) 2.0 bar Performance @ 9 l/min 1.4 bar Performance @ 18 l/min 0.8 bar Maximum flow 35 l/min Maximum static inlet pressure 10 metres Maximum working pressure* 300 kPa (3 bar) Maximum ambient air temperature 40 Ã°C Min / Max water temperature** Min 4 Ã°C / Max 65 Ã°C Flow switch sensitivity (approx) 0.8 l/min Connections Pump connections G male Flexible hoses Connections G female x 15 mm push-in
200 mm long
Isolating valves on inlet hoses
Motor Type Induction, auto-reset thermal trip Duty rating Int (S3) 30 mins on / 30 mins off @
Electrical Power supply/phase/frequency 230 V a.c./ 1 / 50 Hz Current (full load) 1.8 Amps Power consumption 420 Watts Fuse rating 5 Amps Power cable (pre-wired) 1.5 metres Physical Enclosure protection IP22 Length 231 mm Width 132 mm Height (excluding hoses) 166 mm Weight (including fittings) 4.3 Kg
* The maximum pressure that can be applied to the pump under any installation conditions.
** A stored water temperature of 60 Ã°C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.